Unusual water feature

The above feature is currently only an idea, but you
may like to try it and see.
The "frame" is made from copper pipe and each "chute is
made from copper, the water emits only from the top left side as it will
then run down each chute in turn, the angles I will leave up to you

As you can see this version uses 40mm PVC push fit pipe and PVC guttering.
Each piece of gutter has a 40mm hole drilled in it. Each is then slid over
the push fit pipe, 2 on each side. The angle is maintained by gravity
there are no glues or sealants used to hold the guttering.
The pump is connected at the bottom on the right pipe (The one with the
tallest gutter section) The bottom of the push fit pipe is sealed. A small
hole was drilled just above where the top gutter section is. The guttering
was then spaced evenly and the pump switched on.
Water feature ideas
see here